Flex FWD V6-3.5L (2010)
Seat Heater Switch: Service and Repair
Seat Control Switch - Front
Seat Control Switch - Front
Removal
NOTE: The Supplemental Restraint System (SRS) must be fully operational and free of faults before releasing the vehicle to the customer.
1. WARNING: Turn the ignition OFF and wait one minute to deplete the backup power supply. Failure to follow this instruction may result
in serious personal injury or death in the event of an accidental deployment.
For passenger seat, turn the ignition OFF and wait at least one minute.
2. For driver seat, remove the manual recliner handle, if equipped.
1. Locate the clip between the seat cushion and side shield.
2. Remove the clip and slide the handle off the shaft.
3. For passenger seat, remove the manual recliner handle.
1. At the rear outboard side of the seat, pull the flap out to access the recliner handle clip.
2. Locate the clip between the cushion and side shield and pull the clip off.
3. Slide the recliner handle off the shaft.
