Flex FWD V6-3.5L (2010)
3. Remove the Air Cleaner (ACL) outlet pipe. For additional information, refer to Fuel Delivery and Air Induction.
4. Disconnect the brake fluid level indicator switch electrical connector and detach the wire harness.
5. NOTE: The brake tubes must be installed in the same position and orientation as removed.
Disconnect the brake tubes from the master cylinder.
-
To install, tighten to 22 Nm (16 lb-ft).
-
Cap the brake tubes and plug the master cylinder ports.
6. NOTE: Make sure that the master cylinder-to-booster seal is removed with the master cylinder.
Remove and discard the 2 brake master cylinder nuts and remove the brake master cylinder.
-
To install, tighten the new nuts to 20 Nm (177 lb-in).
7. To install, reverse the removal procedure.
-
Bleed the brake system. For additional information, refer to Brakes and Traction Control.