Flex FWD V6-3.5L (2010)
Installation
WARNING: Do not smoke, carry lighted tobacco or have an open flame of any type when working on or near any fuel-related component.
Highly flammable mixtures are always present and may be ignited. Failure to follow these instructions may result in serious personal injury.
NOTICE: During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while
cleaning gasket surfaces that enters the oil passages, coolant passages or the oil pan, may cause engine failure.
NOTICE: Early build engines have 11 fastener valve covers, late build engines have 9 fastener valve covers. Do not attempt to install bolts in
the 2 empty late build valve cover holes or damage to the valve cover will occur.
NOTE: On early build engines, the timing chain rides on the inner side of the RH timing chain guide. Late build engines are equipped with a different
design RH timing chain guide that requires the timing chain to ride on the outer side of the RH timing chain guide. For service, all replacement RH
timing chain guides will be the late build design.
51. Attach all of the wiring harness retainers to the LH valve cover and stud bolts.
52. Connect the 3 LH coil-on-plug electrical connectors.
53. Connect the LH VCT solenoid electrical connector.
54. Attach all of the wiring harness retainers to the RH valve cover and stud bolts.
55. Connect the 3 RH coil-on-plug electrical connectors.