Flex FWD V6-3.5L (2010)
67. Install the engine mount brace, the nut and the bolt.
-
Tighten to 20 Nm (177 lb-in).
68. Install the transaxle support insulator bracket, 3 nuts and the bolt.
-
Tighten the transaxle support insulator bracket nuts to 63 Nm (46 lb-ft).
-
Tighten the transaxle support insulator bolt to 80 Nm (59 lb-ft).
69. Install the transaxle support insulator through bolt and nut.
-
Tighten to 175 Nm (129 lb-ft).
All-Wheel Drive (AWD) vehicles
70. NOTE: A new Power Transfer Unit (PTU) seal must be installed whenever the intermediate shaft is removed.
Install a new PTU seal. For additional information, refer to Transfer Case.
All camshafts
71. Connect the transaxle cooler tubes and install the 2 secondary latches.
72. Install the RH halfshaft support bracket and the 4 bolts.
-
Tighten the halfshaft support-to-cylinder block bolts to 40 Nm (30 lb-ft).
