Flex FWD V6-3.5L (2010)
89. Install the 2 rear engine roll restrictor-to-transaxle bolts.
-
Tighten to 90 Nm (66 lb-ft).
90. Using a new O-ring seal, install the PSP tube onto the steering gear, rotate the clamp plate and install the bolt.
-
Tighten to 25 Nm (18 lb-ft).
91. Install the PSP tube bracket-to-steering gear bolt.
-
Tighten to 10 Nm (89 lb-in).
92. If equipped, attach the oil cooler hose support clip to the subframe.
93. NOTE: Lubricate the engine oil filter gasket with clean engine oil prior to installing the oil filter.
Install a new engine oil filter.
-
Tighten to 5 Nm (44 lb-in) and then rotate an additional 180 degrees.