Flex FWD V6-3.5L (2010)
19. NOTICE: Failure to use Motorcraft(R) High Performance Engine RTV Silicone may cause the engine oil to foam excessively and result in
serious engine damage.
NOTE: If the valve cover is not installed and the fasteners tightened within 4 minutes, the sealant must be removed and the sealing area cleaned.
To clean the sealing area, use silicone gasket remover and metal surface prep. Failure to follow this procedure can cause future oil leakage.
Apply an 8 mm (0.31 in) bead of Motorcraft(R) High Performance Engine RTV Silicone to the engine front cover-to-RH cylinder head joints.
Early build vehicles
20. Using a new gasket, install the RH valve cover, bolt and the 10 stud bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
Late build vehicles
21. Using a new gasket, install the RH valve cover and tighten the 9 stud bolts.
-
Tighten in the sequence shown to 10 Nm (89 lb-in).
All vehicles
22. NOTICE: Failure to use Motorcraft(R) High Performance Engine RTV Silicone may cause the engine oil to foam excessively and result in
serious engine damage.
