Flex FWD V6-3.5L (2010)
Remove Smart Junction Box (SJB) fuse 15 for at least one minute.
6. NOTE: When the ignition switch is switched to the ON position, the HVAC module will initialize and calibrate the actuators. Calibration of the
actuators will take approximately 30 seconds.
Reinstall SJB fuse 15. Turn the ignition switch to the ON position and wait 30 seconds before verifying correct LH temperature blend door
operation.
Auxiliary Mode Door Actuator
Auxiliary Mode Door Actuator
Removal and Installation
1. Remove the LH quarter trim panel.
2. Remove the 2 auxiliary mode door actuator screws.
3. Disconnect the auxiliary mode door actuator electrical connector.
4. Remove the auxiliary mode door actuator.
5. To install, reverse the removal procedure.
Auxiliary Temperature Blend Door Actuator
Auxiliary Temperature Blend Door Actuator