Flex FWD V6-3.5L (2010)
-
Ignition OFF.
-
Observe the stoplamps with the brake pedal released.
-
Are all of the stoplamps illuminated?
Yes
GO to K3.
No
GO to K2.
-------------------------------------------------
K2 CHECK THE STOPLAMPS VOLTAGE SUPPLY CIRCUIT FOR A SHORT TO VOLTAGE
-
Disconnect: SJB C2280d.
-
Do the stoplamps continue to illuminate?
Yes
REPAIR circuit CLS18 (GY/BN) (LH rear lamp) or circuit CLS19 (VT/OG) (RH rear lamp) for a short to voltage. TEST the system for normal
operation.
No
GO to K8.
-------------------------------------------------
K3 CHECK THE STOPLAMP SWITCH
-
Disconnect: Stoplamp Switch C278.
-
Do the stoplamps continue to illuminate?
Yes
If equipped with a TBC module, GO to K4.
If not equipped with a TBC module, GO to K5.
No
INSTALL a new stoplamp switch. REFER to Stoplamp Switch See: Brake Light Switch/Service and Repair. TEST the system for normal operation.
-------------------------------------------------
K4 CHECK THE TBC MODULE
-
Disconnect: TBC Module C2142.
-
Do the stoplamps continue to illuminate?
Yes
GO to K5.
No
INSTALL a new TBC module. TEST the system for normal operation.
-------------------------------------------------