Flex FWD V6-3.5L (2010)
All vehicles
10. Start the engine and let it run for 3 minutes. Move the range selector lever into each gear position and allow engagement for a minimum of ten
seconds. Check the transmission fluid level by installing and removing the transmission fluid level indicator. When installing the transmission fluid
level indicator, be sure it is seated and rotate it clockwise to the locked position. Adjust the transmission fluid level.
1. Correct transmission fluid level at normal operating temperature 82°C-93°C (180°F-200°F).
2. Low transmission fluid level.
3. High transmission fluid level.
Vehicles equipped with a 3.5L GTDI engine
11. Turn the engine off, loosen the clamp and remove the ACL assembly from the ACL outlet pipe and position it aside with the IAT sensor electrical
connector connected.
12. Install the ACL.
1. Position the ACL assembly in the ACL outlet pipe and push down to install it in the 2 rubber grommets.
2. Tighten the clamp.
-
Tighten to 5 Nm (44 lb-in).
3. Install the 2 ACL bolts.
-
Tighten to 5 Nm (44 lb-in).
4. Install the wiring harness retainer on the ACL.