Flex FWD V6-3.5L (2010)
Information Bus: Pinpoint Tests
Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
Communications Network
Pinpoint Tests
Pinpoint Test A: The PCM Does Not Respond To The Scan Tool
Refer to Wiring Diagram Set 14, Module Communications Network for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Refer to Wiring Diagram Set 24, Electronic Engine Controls - 3.5L for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Refer to Wiring Diagram Set 25, Electronic Engine Controls - 3.5L GTDI for schematic and connector information. See: Diagrams/Electrical
Diagrams/Diagrams By Number
Normal Operation
The PCM communicates with the scan tool through the High Speed Controller Area Network (HS-CAN). An Integrated Diagnostic System (IDS) session
cannot be established if PCM communication fails when attempting to identify the vehicle.
This pinpoint test is intended to diagnose the following:
-
Wiring, terminals or connectors
-
PCM
PINPOINT TEST A: THE PCM DOES NOT RESPOND TO THE SCAN TOOL
NOTICE: Use the correct probe adapter(s) when making measurements. Failure to use the correct probe adapter(s) may damage the
connector.
NOTE: Failure to disconnect the battery when instructed will result in false resistance readings. Refer to Battery.
-------------------------------------------------
A1 VERIFY WHETHER OTHER HS-CAN MODULES PASS THE NETWORK TEST
-
Enter the following diagnostic mode on the scan tool: Network Test.
-
In the LH pane of the IDS network test display screen, verify whether any HS-CAN modules passed the network test.
-
Is the text "pass" or a DTC listed next to any of the following modules (if equipped): 4X4 control module, ABS module, Accessory
Protocol Interface Module (APIM), Instrument Cluster (IC), Occupant Classification System Module (OCSM),Parking Aid Module
(PAM), PCM, Power Steering Control Module (PSCM), Restraints Control Module (RCM) or Steering Angle Sensor Module (SASM)?
Yes
If "pass" or a DTC was listed next to the PCM, a network fault is not currently present. GO to Pinpoint Test U to diagnose an intermittent HS-CAN fault
condition. See: Pinpoint Test U: Intermittent No High Speed Controller Area Network (HS-CAN) Communication, Communication Can Be
Intermittently
If "pass" or a DTC was listed next to one or more modules other than the PCM, GO to A2.
No
No modules are currently communicating on the HS-CAN. GO to Pinpoint Test V to diagnose no HS-CAN communication. See: Pinpoint Test V: No
High Speed Controller Area Network (HS-CAN) Communication, All Modules Are Not Responding
-------------------------------------------------
A2 VERIFY COMPUTERS AND CONTROL SYSTEMS INFORMATION PINPOINT TEST QA HAS BEEN CARRIED OUT
