ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Initial Inspection and Diagnostic Overview|Page 2937 > < Initial Inspection and Diagnostic Overview|Page 2935
Page 69
background image

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with a Power Steering Control Module (PSCM), GO to V18.

If the vehicle is not equipped with a PSCM, GO to V19.

No

CONNECT the negative battery cable. GO to V37.

-------------------------------------------------
V18 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE PSCM DISCONNECTED

 

-

Disconnect: PSCM C1463a.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

GO to V19.

No

CONNECT the negative battery cable. GO to V38.

-------------------------------------------------
V19 CHECK THE HS-CAN (+) AND HS-CAN (-) CIRCUITS FOR A SHORT TOGETHER WITH THE IC DISCONNECTED

 

-

Disconnect: IC C220.

-

Measure the resistance between the DLC C251-6, circuit VDB04 (WH/BU), harness side and the DLC C251-14, circuit VDB05 (WH), harness
side.

-

Is the resistance less than 5 ohms?

Yes

If the vehicle is equipped with an APIM, GO to V20.

If the vehicle is not equipped with a APIM, REPAIR the circuits. CONNECT all modules. CONNECT the negative battery cable. CLEAR the DTCs.

Initial Inspection and Diagnostic Overview|Page 2937 > < Initial Inspection and Diagnostic Overview|Page 2935