Flex FWD V6-3.5L (2010)
Parking Assist Control Module: Service and Repair
Parking Aid Module (PAM)
Removal and Installation
1. NOTE: Module configuration is required when a new Parking Aid Module (PAM) is being installed.
Upload the PAM configuration information to the scan tool. For additional information, refer to Programmable Module Installation (PMI) in
Information Bus. See: Powertrain Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and
Relearning/Programmable Module Installation (PMI)
2. Remove the RH C-pillar trim panel.
3. If replacing the parking aid speaker only, proceed as follows:
-
Disconnect the electrical connector.
-
Disengage the clips.
-
Remove the parking aid speaker.
4. If replacing the PAM, proceed as follows:
-
Disconnect the electrical connector.
-
Remove the 2 pin-type screws.
-
Remove the PAM.
5. To install, reverse the removal procedure.
-
Download the configuration information to the PAM. For additional information, refer to PMI in Information Bus. See: Powertrain
Management/Computers and Control Systems/Information Bus/Testing and Inspection/Programming and Relearning/Programmable Module
Installation (PMI)