Flex FWD V6-3.5L (2010)
7. From the rear of the backrest, attach the backrest trim cover J-clip to the backrest frame wire.
8. Roll the backrest trim cover down and install the 3 second row hog rings.
9. Roll the backrest trim cover down and install the 3 first row hog rings.
10. Roll the backrest trim cover all the way down.
11. Route the wire harness and cables out through the sides of backrest trim cover.
12. Position the inboard recliner to the backrest frame and install the 2 inboard recliner-to-backrest frame bolts finger-tight.
-
Make sure the fold-flat cable is routed out through the backrest trim cover before installing the inboard recliner.
13. Position the outboard recliner to the backrest frame and install the 2 recliner-to-backrest frame bolts finger-tight.
-
Make sure the fold-flat cable, manual lumbar cable (if equipped) and backrest feed wire harness are routed out through the backrest trim cover