Flex FWD V6-3.5L (2010)
7. From the rear of the backrest, attach the backrest trim cover J-clip to the backrest frame wire.
8. Roll the backrest trim cover down and install the 3 second row hog rings.
9. Install the 3 first row hog rings.
10. Roll the backrest trim cover all the way down and engage the lower J-clips.
-
If equipped, make sure the manual lumbar cable and side air bag module wire harness are accessible from the outboard side of the backrest
before engaging the lower J-clips.
-
If equipped, make sure the backrest feed wire harness is accessible from the inboard side of the backrest before engaging the lower J-clips.
11. Attach the cushion side shield in the following sequence. Return all retaining clips back to the cushion side shield before attaching to the seat.
1. Align the 4 cushion side shield clips to the seat and push in seating the clips.
2. Install the screw at the front of the cushion side shield.
3. Install the screw at the rear of the cushion side shield.
4. Install the scrivet at the rear of the cushion side shield.
12. If equipped, install the manual lumbar handle in the following sequence.
1. Install the clip onto the manual lumbar handle.
2. Align the splines of the manual lumbar handle to the manual lumbar shaft.
3. Push the manual lumbar handle onto the manual lumbar shaft, seating the clip.
13. Install the recliner cover in the following sequence.
1. Return the barrel nut back to the seat before attaching to the seat.
2. Slide the recliner cover post into the barrel nut on the seat.
3. Install the screw at the rear of the recliner cover.
4. Install the scrivet at the rear of the recliner cover.