Flex FWD V6-3.5L (2010)
4. Connect the large electrical connector.
-
Pivot the connector position assurance lever toward the RCM, drawing the connector in to the RCM.
-
Make sure the thumb tab is engaged to the retainer on the RCM and locked in place.
5. Connect the small electrical connector.
6. Install the LH and RH floor console lower trim panels.
7. Install the front seats. For additional information, refer to the Removal and Installation procedures in Seats.
8. Repower the SRS. For additional information, refer to Supplemental Restraint System (SRS) Depowering and Repowering See: Air Bag
Systems/Air Bag(s) Arming and Disarming/Service and Repair/Supplemental Restraint System (SRS) Depowering and Repowering.
9. If a new RCM was installed, carry out the appropriate steps to complete Programmable Module Installation (PMI). For additional information,
refer to Information Bus.
