Flex FWD V6-3.5L (2010)
3. Remove the D-ring bolt.
-
To install, tighten to 40 Nm (30 lb-ft).
4. Remove the bolt and safety belt retractor.
-
To install, tighten to 40 Nm (30 lb-ft).
5. NOTE: Before installation, make sure the safety belt webbing is not twisted and the safety belts and buckles are accessible to the occupants.
To install, reverse the removal procedure.
6. Check the active restraint system for correct operation. For additional information, refer to the appropriate Functional Test procedure in Safety
Belt System See: Testing and Inspection/Component Tests and General Diagnostics.