Flex FWD V6-3.5L (2010)
Ignition Switch Lock Cylinder: Service and Repair
Ignition Lock Cylinder - Non Functional
Ignition Lock Cylinder - Non Functional
Removal
1. Remove the Passive Anti-Theft System (PATS) transceiver. For additional information, refer to Antitheft and Alarm Systems.
2. Remove the ignition lock cylinder.
1. Use a 1/8-inch diameter drill bit to drill out the lock cylinder retaining pin.
2. Use a 3/8-inch diameter drill to drill down the middle of the ignition lock key slot until the ignition lock cylinder breaks loose.
3. Remove and discard the ignition lock cylinder and drill shavings from the steering column.
3. Remove the bearing retainer.
4. Remove the steering column lock housing bearing and steering column lock gear.
5. Thoroughly clean all drill shavings from the steering column and inspect it for damage.
Installation
1. Install a new ignition lock cylinder.
-
Verify the ignition lock cylinder operation.
2. Install the PATS transceiver. For additional information, refer to Antitheft and Alarm Systems.
3. The new PATS keys must be programmed. For additional information, refer to Integrated Keyhead Transmitter (IKT) Key Programming Using
Diagnostic Equipment in Antitheft and Alarm Systems. See: Accessories and Optional Equipment/Antitheft and Alarm Systems/Testing and
Inspection/Programming and Relearning/Integrated Keyhead Transmitter (IKT) Key Programming Using Diagnostic Equipment