Flex FWD V6-3.5L (2010)
2. Install the elbow connector back onto the feed tube and add a tie strap to the connection. The tie strap may be obtained locally and should measure
approximately 8" (20.3 cm) long x 3/16" (4.5 mm) wide. Trim off excess tie strap after securing elbow connection back onto feed tube. (Figure 3)
3. Verify rear window washer operation. If the rear washer operation remains inoperative, continue with normal WSM, Section 501-16 diagnostics.
WARRANTY STATUS: Eligible Under Provisions Of New Vehicle Limited Warranty Coverage
IMPORTANT: Warranty coverage limits/policies are not altered by a TSB. Warranty coverage limits are determined by the identified causal part.
OPERATION
DESCRIPTION
TIME
092105A
2010 Flex: Inspect,
0.2 Hr.
Reconnect And Secure
The Washer Hose
Following The Service
Procedure (Do Not Use
With Any Other Labor
Operations)
DEALER CODING
CONDITION
BASIC PART NO.
CODE
17408
42
Disclaimer