Flex FWD V6-3.5L (2010)
Windshield Washer Pump: Service and Repair
Washer Pump
Washer Pump
Removal and Installation
1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.
2. Remove the RH front fender splash shield.
3. WARNING: Carefully read cautionary information on product label. For EMERGENCY MEDICAL INFORMATION seek medical
advice. In the USA or Canada on Ford/Motorcraft products call: 1-800-959-3673. For additional information, consult the product
Material Safety Data Sheet (MSDS) if available. Failure to follow these instructions may result in serious personal injury.
NOTE: When installing a new washer pump, be careful not to damage the rubber grommet.
NOTE: To prevent spilling washer fluid, drain the washer reservoir before washer pump removal.
Remove the washer pump.
-
Disconnect the washer pump electrical connector.
-
Disconnect the washer hoses.
-
Remove the windshield washer pump.
4. NOTICE: Do not operate the washer pump prior to filling the washer reservoir. Failure to follow this instruction may result in
premature pump failure.
To install, reverse the removal procedure.
-
Fill the washer reservoir with windshield washer fluid.
