Flex FWD V6-3.5L (2010)
Wiper Arm: Service and Repair
Wiper Mounting Arm and Pivot Shaft
Wiper Mounting Arm and Pivot Shaft
Removal and Installation
1. Remove the cowl panel grille.
2. Remove the 3 wiper mounting arm and wiper pivot shaft bolts.
-
To install, tighten to 18 Nm (159 lb-in).
3. Disconnect the electrical connector and detach the wire harness pin-type retainer.
4. Remove the wiper mounting arm and wiper pivot shaft.
5. To install, reverse the removal procedure.
-
Adjust the wiper pivot arms. For additional information, refer to Wiper Blade and Pivot Arm Adjustment - Windshield See: Adjustments.