Focus L4-2.0L (2009)
7. Rotate the Front End Accessory Drive (FEAD) belt tensioner clockwise and remove the belt from the generator drive pulley. Position the FEAD
belt aside.
8. Release the 2 retainers and remove the lower generator air duct.
9. Position the protective cover aside, remove the nut and position the generator B+ terminal aside.
10. Remove the 2 generator nuts.
11. Remove the 2 generator studs.
12. Remove the generator bolt and the generator.
13. If necessary, remove the bolt and the generator upper air duct.
Installation
1. If removed, install the generator upper air duct and the bolt.
-
Tighten to 12 Nm (106 lb-in).
2. Install the generator and generator bolt. Hand-tighten the bolt. Do not torque the bolt at this time.
3. Install the 2 generator studs.
-
Tighten to 24 Nm (18 lb-ft).
4. Install the 2 generator nuts.
-
Tighten to 47 Nm (35 lb-ft).
5. Tighten the generator bolt.
-
Tighten to 47 Nm (35 lb-ft).
6. Position the generator B+ terminal on the generator and install the nut.
-
Tighten the nut to 17 Nm (150 lb-in) and position the protective cover on the nut.
7. Install the lower generator air duct.
8. Rotate the FEAD belt tensioner clockwise and install the FEAD belt.
9. Position the accessory drive splash shield and install the 2 screws.
-
Tighten the screws to 5 Nm (44 lb-in).
10. Install the center support bracket and the 3 bolts.
-
Tighten the bolts to 30 Nm (22 lb-ft).
11. Install the RH halfshaft.
12. Connect the generator electrical connector.
13. Connect the battery.