Focus L4-2.0L (2009)
4. NOTICE: Make sure the boot is correctly aligned with the vent tube and the raised alignment mark on the steering gear. Incorrect
venting may lead to internal steering gear component damage.
NOTE: Right side shown, left side similar.
NOTE: To prevent the boot from twisting during toe adjustment, apply the specified grease to the groove in the tie rod and uniformly to the inner
diameter of the boot.
NOTE: Make sure the tie rod is clean before installing the boot.
Position the steering gear bellows boot onto the inner tie rod.
5. NOTE: Install new inner and outer bellows boot clamps.
To install, reverse the removal procedure.
-
Use the Boot Clamp Pliers to tighten the new inner bellows boot clamp.
6. Check and, if necessary, adjust the front toe.
