Focus L4-2.0L (2009)
Transmission Mount: Service and Repair
Transaxle Support Insulator - Anti-Roll
4F27E
Transaxle Support Insulator - Anti-Roll
Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the 2 bolts and the nut, rotate the bottom of the engine forward enough so the roll restrictor clears the subframe and remove the roll
restrictor.
Installation
1. NOTICE: The roll restrictor bolts are different lengths. If the long bolt is used to hold the roll restrictor to the subframe, damage to the
steering rack may occur.
Position the roll restrictor in place and loosely install the roll restrictor-to-subframe bolt.
2. Install the roll restrictor-to-transaxle bracket bolt and tighten both of the roll restrictor bolts.
-
Tighten to 70 Nm (52 lb-ft).
