Focus L4-2.0L (2009)
-
Measure the plunger length.
-
Speed control deactivation switch (green) XX mm = 24 mm (0.94 in).
-
Brake lamp switch (grey) XX mm = 21 mm (0.82 in).
-
Starter safety switch (black) XX mm = 26 mm (1.02 in).
7. NOTICE: When installing the switches, the brake lamp switch is rotated counterclockwise and the remaining switches are rotated
clockwise. Failure to follow this instruction will result in the switch plungers binding inside the switch.
NOTE: The speed control deactivation switch and the stoplamp switch are automatically adjusted during installation.
NOTE: A slight ratcheting noise and feel during installation of the speed control deactivation switch and the brake lamp switch is normal.
Install the switches to the pedal assembly.
1. Speed control deactivation switch (green).
2. Brake lamp switch (grey).
3. Clutch position switch (red).
4. Starter safety switch (black).
8. NOTE: The colors of the electrical connectors and the switches are identical.
Connect the electrical connectors to the pedal assembly switches.
9. NOTE: A slight ratcheting noise and feel during switch adjustment is normal.
Adjust the starter safety switch (black) by pressing and then releasing the clutch pedal.
10. NOTE: Install new O-ring seals.
Connect the clutch master cylinder and slave cylinder fluid supply tubes to the clutch master cylinder, then insert the clips.
11. Connect the hood release cable and the DLC to the instrument panel lower panel.