Focus L4-2.0L (2009)
Rear Door Window Glass Weatherstrip: Service and Repair
Door Glass Top Run - Rear
Door Glass Top Run - Rear
Removal and Installation
1. Remove the rear door speaker.
2. NOTE: Do not touch the adhesive surface during removal or installation of the watershield, as re-bonding will be impaired. If additional adhesive
is required during installation, apply seam sealer as necessary to completely seal the watershield to the inner door.
Remove the watershield.
3. Temporarily install the window control switch or the window regulator handle to raise or lower the window to align the regulator clamp with the
access hole.
4. Push out the pin and then push out the sleeve of the 2-part spacer.
5. Supporting the glass, lower the glass and regulator to the lowest position.
6. Remove the door glass top run.
7. To install, reverse the removal procedure.