Focus L4-2.0L DOHC VIN 5 (2003)
shift mechanism.
NOTE: Do not fully tighten the bolts at this stage.
Install the TR sensor (automatic transaxle shown removed for clarity).
2. Using the special tool, align the TR sensor and tighten the bolts.
3. CAUTION: Do not use air tools on this bolt. Hold the manual control lever while tightening the manual control lever bolt, failure to the manual
control lever shaft could occur.
Install the manual control lever.
4. CAUTION: Check the manual control lever is in position "3" same as "D" position.
Adjust the manual control lever to TR sensor "D" position.
1
"1" Low 1
2
"2"Low 2
3
"D" Drive
4
"N" Neutral
5
"R" Reverse
6
"P" Park
^
When in position "D" the marks on the manual control lever line up with the marks on the TR Sensor.