Focus L4-2.0L DOHC VIN 5 (2003)
6. Remove the shift lever.
1
Remove the rubber cap and the securing clip.
2
Remove the shift lever.
^
Remove the boot from the selector lever.
7. Remove the selector lever.
8. Remove the gearshift control shaft oil seal.
^
Clean up the shaft.
Installation
1. NOTE: The third gear must be engaged.
Remove the boot from the new oil seal.
2. CAUTION: Make sure that there is no adhesive tape lost under the sealing lip of the gearshift control shaft oil seal.
NOTE: Install a thin adhesive tape to the gear shaft to avoid damages of the oil seal from the bore or from the ring groove.