Focus L4-2.0L DOHC VIN 5 (2003)
4. Remove the intermediate shaft center bearing retaining nuts and cap.
^
Discard the cap and nuts
5. CAUTION: Support the halfshaft. The inner joint must not bent more than 18 degrees. The outer joint must be bent more than 45 degrees.
Detach the intermediate shaft and halfshaft from the transaxle and secure it to one side.
^
Allow the oil to drain into a suitable container
6. Using the special tools, remove the halfshaft oil seal (left-hand side shown right-hand side similar).
Installation
1. Using the special tool, install the halfshaft oil seal.
