Focus L4-2.0L VIN N (2006)
Wheel Speed Sensor: Service and Repair
Wheel Speed Sensor - Rear
Wheel Speed Sensor - Rear
Removal and Installation
1. Disconnect the battery ground cable. For additional information, refer to Battery.
2. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Maintenance/Service and Repair.
3. Remove the wheel speed sensor bolt.
^
To install, tighten to 9 Nm (80 inch lbs.).
4. NOTE: Not all the clips are part of the sensor assembly and may not be reusable.
Disconnect the wheel speed sensor wiring harness electrical connector.
^
Remove the sensor by detaching the small clip and pulling the sensor grommets out of the clips.
5. To install, reverse the removal procedure.