Focus L4-2.0L VIN N (2006)
11. Remove the engine roll restrictor mount bolt.
-
To install, tighten to 48 Nm (35 lb-ft).
12. NOTE: This step requires an assistant.
Position the engine forward and remove the generator.
13. If necessary, remove the 2 generator stud bolts.
-
To install, tighten to 24 Nm (18 lb-ft).
14. If necessary, remove the 3 nuts and the generator upper air duct.
-
To install, tighten to 4 Nm (35 lb-in).
15. If necessary, remove the cap, nut and position the radial adapter aside.
-
To install, tighten to 11 Nm (8 lb-ft).
16. To install, reverse the removal procedure.