Focus L4-2.0L VIN N (2006)
7. Open the LH and RH assist handle covers.
8. Remove the LH and RH assist handles.
-
Rotate the retaining clips 90 degrees.
9. Partially lower the front portion of the headliner and block with a suitable material.
10. Clean the interior and exterior of the windshield glass surface with a non-alcohol based glass cleaner.
11. Cut the urethane adhesive applicator tip to the specification.
12. NOTE:
-
Use either a high-ratio, electric or battery-operated caulk gun that will apply the urethane with less effort and a continuous bead.
-
Make sure that all gaps in the urethane adhesive are smoothed into one continuous bead.
Apply urethane adhesive over the top of the existing urethane adhesive.
-
Apply the urethane to the top and sides of the windshield from the interior of the vehicle.
-
Apply the urethane to the bottom of the windshield from the exterior of the vehicle.
13. NOTE: The urethane adhesive must cure for a minimum of 1 hour before testing for air or water leaks.
After the urethane has cured, check the windshield seal for air or water leaks through the urethane adhesive bead and add urethane adhesive as
necessary.
14. Position the front portion of the headliner.
