Focus L4-2.0L VIN N (2006)
adhesive are smoothed into 1 continuous bead starting and ending at the bottom of the windshield near the center.
10. Install the windshield glass weatherstrip.
11. Install the windshield glass on the vehicle aligning it with the markings made previously.
12. CAUTION: When installing urethane-installed glass parts, the vehicle must not be driven until the urethane has cured. Adequate cure
time is specified on the drive away chart for each urethane product as the temperatures and humidity vary. Inadequate or incorrect
curing can adversely affect the retention of the windshield.
After the urethane has cured, check the windshield glass seal for air or water leaks through the urethane adhesive bead and add urethane adhesive
as necessary.
13. Remove the spacers and attach the headliner to the roof panel.
14. Install the sun visor retaining clips.
1
Install the screws.
2
Close the covers.
15. Install the LH and RH sun visors and the 4 screws.
16. Install the interior mirror.
17. If equipped, connect the electrical connectors and install the interior lamp.
18. If equipped, install the overhead console.
19. Install the A-pillar trim panels.
20. Install the cowl panel grilles.
