Focus L4-2.3L VIN Z (2003)
Using the crankshaft pulley bolt, turn the crankshaft clockwise and position the No. 1 piston at TDC. Install the special tool in the slots on the rear
of both camshafts.
5. Remove the plug bolt.
6. NOTE: After the No. 1 piston is set in the TDC position and the Timing Peg is installed, the Timing Peg will stop the engine from turning in a
clockwise direction.
Install the special tool.
7. Remove the degas bottle.
8. Remove the battery.
9. Remove the three bolts and the battery tray.