Focus L4-2.3L VIN Z (2003)
Vehicles with seat side air bags
18. Remove the restraint system diagnostic tools from the vehicle harness side of the driver and passenger seat side air bag module electrical
connectors.
19. Connect the driver and passenger seat side air bag module electrical connector.
All Vehicles
20. WARNING: The restraint system diagnostic tool is for restraint system service only. Remove from vehicle prior to road use. Failure to
remove could result in injury and possible violation of vehicle safety standards.
Make sure all restraint system diagnostic tool(s) that may have been installed during the repair have been removed from the vehicle and all SRS
components are connected.
21. Turn the ignition switch from OFF to ON.
22. Install the RCM fuse F2.60 (7.5A) to the CJB and install the cover.
23. WARNING: Be sure that nobody is in the vehicle and that there is nothing blocking or set in front of any air bag module when the
battery ground cable is connected.
Connect the battery ground cable.
24. Prove out the supplemental restraint system (SRS) as follows:
Turn the ignition key from ON to OFF. Wait 10 seconds, then turn the key back to ON and visually monitor the air bag indicator with the air bag
modules installed. The air bag indicator will light continuously for approximately six seconds and then turn off. If an air bag supplemental
restraint system (SRS) fault is present, the air bag indicator will either:
-
fail to light.
-
remain lit continuously.
-
flash at a 5 Hz rate (RCM not configured).
The air bag indicator may not illuminate until approximately 30 seconds after the ignition switch has been turned from the OFF to the ON
position. This is the time required for the restraints control module (RCM) to complete the testing of the SRS. If the air bag indicator is inoperative
and a SRS fault exists, a chime will sound in a pattern of five sets of five beeps. If this occurs, the air bag indicator and any SRS fault discovered
must be diagnosed and repaired.
Clear all continuous DTCs from the restraints control module using a scan tool.
