ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

Engine Controls - Driveability Concerns/DTC's Set|Page 4578 > < Engine Controls - General PCM Programming Procedures|Page 4573
Page 1
background image

PROM - Programmable Read Only Memory: All Technical Service Bulletins
Engine Controls - Driveability Concerns/DTC's Set

Article No.
03-20-9

10/13/03

DRIVEABILITY - DIAGNOSTIC TROUBLE CODE (DTC)
P0068 - CRANK NO START - HESITATION AT 120
KM/H (75 MPH) - 2.3L PZEV ENGINE

FORD:
2003 FOCUS

ISSUE
Some 2003 Focus 2.3L PZEV (Partial Zero Emissions Vehicle) vehicles may exhibit any of the following conditions.

^

Intermittent Crank No Start

^

Diagnostic Trouble Code (DTC) P0068 (MAP/MAF

-

Throttle Position Correlation)

^

Hesitation/Surge At 120 km/h (75 MPH)

ACTION
Using the Worldwide Diagnostic System (WDS) Reprogram the Powertrain Control Module (PCM). Ensure that the WDS is updated with the Software
Version listed in the PCM Calibration Information Chart. Verify that the PCM calibration updates to the level listed.

Obtain an Authorized Modifications Decal (FPS 8262 - obtainable through DOES II, 25/pkg) and list the date, dealer number, and summary of
modifications performed. Select a prominent place adjacent to the Vehicle Emission Control Information Decal suitable for installing the Authorized
Modifications Decal. Clean the area, install the decal, and cover it with a clear plastic decal shield

OTHER APPLICABLE ARTICLES: NONE 
WARRANTY STATUS: INFORMATION ONLY

Engine Controls - Driveability Concerns/DTC's Set|Page 4578 > < Engine Controls - General PCM Programming Procedures|Page 4573