Focus L4-2.3L VIN Z (2003)
Installation
1. CAUTION: Always apply a liberal bead of electrical grease XG-12 to the driver air bag module electrical connector face prior to connecting the
driver air bag module electrical connector to the clockspring. Failure to follow this instruction may result in poor connectivity and may set
intermittent/on-demand supplemental restraint system (SRS) DTCs.
Apply electrical grease XG-12 to the driver air bag module electrical connector face.
2. Connect the driver air bag module electrical connector.
3. WARNING: The driver air bag module should only be inverted long enough for the horn switch contact plate to be installed. Handle with extreme
care making sure that, if for any reason this procedure is interrupted, the driver air bag module is turned the correct way up, with the trim cover
side uppermost. Failure to follow these instructions may result in personal injury.
CAUTION: To prevent damage to the driver air bag module, wiring harness or steering wheel do not insert any tool between the driver air bag
module and the steering wheel.
NOTE: Turn the steering wheel to access the air bag module captive bolts.
Attach the driver air bag module to the steering wheel.
-
1.Attach the driver air bag module retaining clips.
-
2.Install the captive bolts.
4. Repower the system. For additional information, See: Air Bag(s) Arming and Disarming/Service and Repair
