Focus L4-2.3L VIN Z (2003)
Attach the halfshaft to the transaxle.
3. CAUTION: The lower arm pinch bolt must be installed from the rear of the wheel knuckle.
CAUTION: Make sure the heat shield is installed to prevent damage to the ball joint.
Attach the lower arm hall joint to the wheel knuckle.
1
Attach the ball John to the wheel knuckle.
2
Install the nut and bolt.
4. WARNING: Install a new tie-rod end retaining nut. Failure to follow this instruction may result in personal injury.
Attach the tie-rod end to the wheel knuckle.
5. Check the transaxle fluid level and top up with manual transmission fluid, if necessary.
6. Install the wheel and tire.
7. Tighten the strut and spring assembly top mount retaining nuts.
Halfshaft Seal RH
Halfshaft Seal RH