The quarter panel section to be replaced, rear lamp retaining plate, rear inner quarter panel, back panel with reinforcement and rear floor panel section to be replaced must be removed before starting repairs.
Reposition the carpeting and the wiring harness away from the working area.
Rear side member
NOTE:The cut location may vary depending upon the extent of the damage.
Cut location.
Installation
NOTE:Before resistance spot welding of body panels with a total panel thickness of 3 mm and greater, the welding equipment instructions contained in sub-section 501-25 must be followed.
Fit the rear bumper mounting with the straightening angle and secure. Insert and fit the side member.