Noise, Vibration and Harshness - Powertrain/Drivetrain Mount Neutralizing
Focus 2004.75 (07/2004-)
General Procedures
NOTE:There is no procedure for neutralizing the powertrain/drivetrain mounts. To check the alignment of the powertrain mounts visually, proceed as follows.
Loosen the rear support insulator retaining bolts (if equipped).
Loosen the powertrain/drivetrain mount retaining bolts.
NOTE:Support the powertrain/drivetrain in an approximate position and height.
NOTE:Make sure that the right-hand mount and left-hand insulator align over the studs on the powertrain and drivetrain to allow the fixings to be assembled through the large holes in the support insulator bracket without overstraining.
Check the powertrain/drivetrain mount alignment.
Tighten the powertrain/drivetrain mount to powertrain/drivetrain mount bracket retaining bolts.
Tighten the powertrain/drivetrain mount to body retaining bolts.
Tighten the rear support insulator retaining bolts (if equipped).