| Removal and Installation Name Specification Formula E Engine Oil SAE 5W-30
WSS-M2C911-A1 | | -
WARNING:Do not smoke or carry lighted tobacco or open flame of any type when working on or near any fuel related components. Highly flammable vapors are always present and may ignite. Failure to follow these instructions may result in personal injury. WARNING:This procedure involves fuel handling. Be prepared for fuel spillage at all times and always observe fuel handling precautions. Failure to follow these instructions may result in personal injury. WARNING:The fuel system remains pressurized for a long time after the ignition is switched off. The fuel pressure must be relieved before attempting any repairs. failure to follow this instruction may result in personal injury. Release the fuel system pressure.
For additional information, refer to: Fuel System Pressure Release - 1.4L Duratec-16V (Sigma)/1.6L Duratec-16V Ti-VCT (Sigma)/1.8L Duratec-HE (MI4)/2.0L Duratec-HE (MI4) (310-00 Fuel System - General Information, General Procedures).
| | | -
Disconnect the battery ground cable.
For additional information, refer to: Battery Disconnect and Connect (414-01 Battery, Mounting and Cables, General Procedures).
| 3. Remove the components in the order indicated in the following illustration(s) and table(s). 4. To install, reverse the removal procedure. | | -
Initialize the door window motors.
For additional information, refer to: Door Window Motor Initialization (501-11 Glass, Frames and Mechanisms, General Procedures).
| Installation Details Item 2 : Fuel pulse damper O-ring seals | | -
CAUTION:Do not use silicone grease to lubricate O-ring seals as it will block the fuel injectors. NOTE:Install a new fuel pulse damper O-ring seals. Lubricate the fuel pulse damper O-ring seal with clean engine oil to aid installation. | |
-1.6L Duratec-16V (Sigma)/Description and Operation/Diagnosis and Testing/Removal and Installation//img/E45233.jpg)
