ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Blower Motor Resistor - LHD > < Temperature Blend Door Actuator

Focus 2004.75 (07.2004-)

Control Components - Blower Motor Resistor—RHD Focus 2004.75 (07/2004-)
Removal and Installation

1. Remove the components in the order indicated in the following illustration(s) and table(s).

WARNING:
WARNING:Never perform operations on the blower motor resistor before the blower motor resistor has cooled to ambient temperature. Failure to observe this instruction can lead to injury.

 
Item
Part Number
Description
1
-
Footwell trim panel
2
-
Glove compartment screws
See Removal Detail
3
-
Hose, glove compartment cooling (if equipped)
See Removal Detail
4
-
Glove compartment
See Removal Detail
5
-
Electrical connector, additional audio input
6
-
Passenger air bag deactivation (PAD) switch electrical connector (if equipped)

 
Item
Part Number
Description
7
-
Opening damper, glove compartment cover (unhook)
8
-
Glove compartment cover

 
Item
Part Number
Description
9
-
Blower motor resistor connector
10
-
Blower motor resistor bolts
11
-
Blower motor resistor

2. To install, reverse the removal procedure.

Removal Details

Item 2 : Glove compartment screws
  1. Fold down the covering caps of the screws for the glove compartment.

Item 3 : Hose, glove compartment cooling (if equipped)
  1. Detach the central junction box (CJB) from the reinforcing element.

  1. Detach the CJB from the CJB bracket.
    1. Turn the CJB downwards.
    1. Pull out the CJB.

  1. Detach the glove compartment cooling hose from the glove compartment.

Item 4 : Glove compartment
  1. Remove the access flap for the navigation system DVD mechanism (if equipped).

Blower Motor Resistor - LHD > < Temperature Blend Door Actuator