| Removal and Installation 2. Remove the components in the order indicated in the following illustration(s) and table(s). 5 - Battery positive cable electrical connector 6 - Battery positive and battery negative cable retaining clip 7 - Battery ground cable to body electrical connector 8 - Battery to transaxle ground cable electrical connector 9 - Starter motor solenoid electrical connector 10 - Starter motor battery positive cable electrical connector retaining nut 11 - Starter motor solenoid cable electrical connector retaining nut 12 - Starter motor solenoid electrical connector 13 - Fuel filter splash shield 14 - Generator battery cable electrical connector 15 - Battery positive and negative cables 3. To install, reverse the removal procedure. Removal Details Item 2 : Battery ground cable terminal clamp | | -
Detach the battery ground cable terminal clamp. For additional information, refer to Battery Disconnect - in this section. | Item 3 : Battery retaining bracket retaining nut | | -
Remove the battery retaining bracket retaining nut, to allow the battery ground cable to be removed from under the battery retaining bracket. | Item 4 : Battery positive cable terminal clamp cover | | -
Release the battery positive cable terminal shield locking tangs and remove the shield. | Installation Details Item 2 : Battery ground cable terminal clamp | | -
Connect the battery ground cable. For additional information, refer to Battery Disconnect - in this section. | |
