Removal and Installation 1. Remove the components in the order indicated in the following illustration(s) and table(s). 3 - Dipped beam switch connector 2. To install, reverse the removal procedure. Removal Details Item 1 : Driver side air vent | -
NOTE:The air vent is held in place by four retaining tangs. Disengage the upper retaining tangs and pull the air vent forwards until the lower retaining tangs are accessible. Remove the passenger side air vent. - Using a thin bladed screwdriver, release the locking tangs.
| Item 2 : Dipped beam switch | -
Unclip the dipped beam switch through the driver side air vent cut-out. | |