| Removal and Installation | | -
Move the roof opening panel shield rearwards. | 2. Remove the components in the order indicated in the following illustration(s) and table(s). 3 - Roof opening panel glass 3. To install, reverse the removal procedure. Removal Details Item 1 : Roof opening panel guide arm covers | | -
NOTE:Make sure the roof opening panel is in the closed position. Starting at the rear of the roof opening panel, remove the roof opening panel guide arm covers (left-hand side shown). - Release the lower clip.
- Release the upper clip.
| Installation Details Item 2 : Roof opening panel glass retaining screws | | -
NOTE:Do not fully tighten the retaining screws at this stage. Install the roof opening panel glass retaining screws on both sides (left-hand side shown). | | | -
Adjust the rear edge of the roof opening panel glass. - Push the rear edge up or down to give the correct alignment (flush to + 1 mm).
| | | -
Make sure that the roof opening panel glass is located centrally in the roof panel opening. | | | -
Tighten the roof opening panel glass rear retaining screws (left-hand side shown). | | | -
Adjust the front edge of the roof opening panel glass. - Push the front edge up or down to give the correct alignment (flush to -1 mm).
- Tighten the front retaining screws (left-hand side shown).
| | | -
Operate the roof opening panel and check the alignment. | Item 1 : Roof opening panel guide arm covers | | -
NOTE:An audible click can be heard when the lower edge of the guide arm cover is correctly located. Starting at the front of the roof opening panel, install the roof opening panel guide arm covers (left-hand side shown). - Install the upper clip.
- Install the lower clip.
| | 
