ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Front Bumper Cover - Vehicles Built From: 12-2007 > < Front Bumper Cover - Vehicles Built Up To: 12-2007

Focus 2004.75 (07.2004-)

Bumpers - Front Bumper Focus 2004.75 (07/2004-)
Removal and Installation

Removal

  1. Remove the front bumper cover.
    For additional information, refer to Front Bumper Cover - in this section.

  1. Remove the radiator splash shield.

  1. Disconnect the power steering pump electrical connectors.

  1. Detach the power steering pump support bracket from the bumper.

  1. Disconnect the air temperature sensor electrical connector.

  1. Remove the air temperature sensor.
    • Release the clip.

  1. Remove the horn and bracket assembly.
    1. Disconnect the electrical connector.
    1. Remove the bolt.

  1. Detach the wiring harness from the bumper on both sides (left-hand side shown).
    • Detach the clips.

  1. Remove the air deflector on both sides (left-hand side shown).

  1. Detach the radiator grille opening panel reinforcement from the bumper on both sides (right-hand side shown).

  1. Detach the intake air resonator from the bumper.

  1. Support the radiator on both sides (left-hand side shown).
    • Using cable ties, secure the radiator to the radiator grille opening panel reinforcement.

  1. Detach the radiator support bracket from the bumper on both sides (left-hand side shown).

  1. Remove the bumper.

Installation

  1. To install, reverse the removal procedure.

Front Bumper Cover - Vehicles Built From: 12-2007 > < Front Bumper Cover - Vehicles Built Up To: 12-2007