| Removal and Installation Name Specification Cleaner WSK-M5B401-A1 Adhesive WSK-M2G402-A4 | | -
Detach the armrest pivot pins from the armrest retaining bracket on both sides (if equipped). - Pull the outer edge of the armrest backing panel upwards to gain access to the spring clip.
- Using a thin bladed screwdriver, release the spring clip.
| | | -
Remove the armrest (if equipped). - Slide the armrest upwards.
- Slide the armrest outwards.
| | | -
Remove the armrest backing panel (if equipped). - Detach the retaining clips from the left hand rear seat backrest in the sequence shown.
| | | -
Fold the rear seat cushions forwards. | | | -
Release the rear seat backrest upper latch on both sides. | | | -
Fold the rear seat backrests forwards. | | | -
Release the rear seat backrest from the outer mounting bracket on both sides. - Using a suitable pair of long nose pliers, depress the clips.
- Push the clip inwards.
- Using a suitable screwdriver, release the locking latch.
| | | -
CAUTION:The left-hand rear seat backrest inner pivot pin has radial grooves. Take care not to damage the right-hand seat backrest inner pivot bush. Remove the right-hand rear seat backrest. - Detach the outer pivot pin from the mounting bracket.
- Detach the right-hand seat backrest from the left-hand seat backrest.
| | | -
CAUTION:Make sure a webbing retainer is installed at least 200 mm towards the safety belt retractor from the webbing stop. Install the safety belt webbing retainer. | | | -
CAUTION:The bolt securing the safety belt anchor is held captive by a metal washer. The bolt, spacer and metal washer must remain on the safety belt anchor at all times when the safety belt is detached or removed. Remove the rear center safety belt lower anchor retaining bolt. | | | -
CAUTION:The left-hand rear seat backrest inner pivot pin has radial grooves. Take care not to damage the center hinge pivot bush. Remove the left-hand rear seat backrest. - Detach the outer pivot pin from the outer mounting bracket.
- Slide the backrest from the center mounting bracket.
| 12. Remove the components in the order indicated in the following illustration(s) and table(s). 2 - Rear center safety belt webbing trim panel 13. To install, reverse the removal procedure. Removal Details Item 1 : Rear center safety belt retractor upper anchor retaining bolt | | -
Detach the rear seat backrest carpet from the left-hand rear seat backrest. | Item 3 : Left-hand backrest cover and pad | | -
Remove the backrest outer pivot pin bush. - Remove the pivot pin bush retaining bolt.
- Remove the bush.
| | | -
Detach the rear seat cover and pad from the rear seat backrest. | | | -
Feed the rear center seat safety belt and anchor through the reat seat cover and pad. | | | -
Raise the rear seat cover and pad to gain access to the rear center safety belt retractor. | Item 4 : Rear center safety belt retractor | | -
Remove the rear seat center safety belt retractor. - Release the locking tang.
| Installation Details Item 4 : Rear center safety belt retractor | | -
CAUTION:Make sure the rear center safety belt retractor locating tang is correctly located. Install the rear center seat belt retractor. - Locate the locking tang.
- Install the retaining bolt.
| Item 1 : Rear center safety belt retractor upper anchor retaining bolt | | -
Using a suitable cleaner, remove the old adhesive from the rear seat backrest. | | | -
Using a suitable adhesive, attach the rear seat backrest carpet to the rear seat backrest. | | 
