ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
206-09B Anti-Lock Control - Traction Control > < Rear Wheel Speed Sensor

Focus RS 2003 (09.2002-)

Anti-Lock Control - Rear Wheel Speed Sensor Ring—2.0L Duratec-RS (Zetec) Focus RS 2003 (09/2002-)
Removal and Installation

Removal

  1. Remove the wheel hub. For additional information, refer to Section  204-02 Rear Suspension.

  1. Remove and discard the wheel speed sensor ring.

  1. Remove and discard the wheel speed sensor ring adapter.

Installation

  1. CAUTION:
    CAUTION:Make sure the wheel speed sensor ring adapter is clean.
    CAUTION:
    CAUTION:Do not apply excessive force when installing the wheel speed sensor ring adapter.
    Install a new wheel speed sensor ring adapter.
  1. CAUTION:
    CAUTION:Make sure the wheel speed sensor ring is not knocked, damaged and keep free from metal fragments.
    CAUTION:
    CAUTION:Protect the face of the wheel speed sensor ring with a suitable non-ferrous flat block to prevent damage.
    CAUTION:
    CAUTION:Make sure the wheel speed sensor ring is pressed on slowly and squarely until fully seated.
    CAUTION:
    CAUTION:Do not exceed a maximum load of 12 kn.
    Using a suitable hydraulic press install a new wheel speed sensor ring.
  1. Install the wheel hub. For additional information, refer to Section  204-02 Rear Suspension.

206-09B Anti-Lock Control - Traction Control > < Rear Wheel Speed Sensor