| Removal and Installation Removal All vehicles | | -
NOTE:This step is only necessary if a new GEM is to be installed. Using WDS read out the vehicle-specific data.
For additional information, refer to: Module Configuration (418-01 Module Configuration, General Procedures).
| Left-hand drive vehicles | | -
Remove the glove compartment. | Right-hand drive vehicles | | -
Remove the footwell trim panel. | All vehicles | | -
Disconnect the GEM electrical connectors. | Installation | | -
To install, reverse the removal procedure. | | | -
Configure the GEM.
For additional information, refer to: Module Configuration (418-01 Module Configuration, General Procedures).
| |
