ford Workshop Repair Guides

Ford Workshop Service and Repair Manuals

ABOUT US
Rear Bumper Cover - 2.0L Duratec-RS (Zetec) > < Specifications - 2.0L Duratec-RS (Zetec)

Focus RS 2003 (09.2002-)

Bumpers - Front Bumper Cover—2.0L Duratec-RS (Zetec) Focus RS 2003 (09/2002-)
Removal and Installation

Removal
  1. Remove the radiator air deflector.
    1. Remove the push pins.
    1. Detach the clips.

  1. Remove the radiator grille.
  1. Raise and support the vehicle. For additional information, refer to Section  100-02 Jacking and Lifting.

  1. Detach the fender splash shield from the bumper cover on both sides.

  1. Detach the fender splash shield from the radiator splash shield on both sides.

  1. Detach the bumper cover from the fender on both sides.
  1. Lower the vehicle.

  1. CAUTION:
    CAUTION:Protect the bumper cover using a soft cloth to prevent damage.
    Detach the bumper cover from the radiator grille opening panel reinforcement.
    • Detach the clips.

  1. Disconnect the turn signal lamp and fog lamp electrical connectors.

  1. Remove the bumper cover.
    1. Detach the clips.
    1. Lower the bumper cover.

Installation

  1. To install, reverse the removal procedure.

Rear Bumper Cover - 2.0L Duratec-RS (Zetec) > < Specifications - 2.0L Duratec-RS (Zetec)