Removal and Installation Name Specification Rear floor panel Spare wheel bracket Removal | -
General notes - Before beginning the repair, remove the back panel and reinforcement, the inner quarter panel and wheel housing, the water drain panel and the water drain panel reinforcement.
- Pay attention to the cut of the replacement part.
| | -
Floor panel - Rough cut.
- Rough cut. Do not damage the reinforcement underneath.
| | -
Inner quarter panel/wheel housing join - Detach the spot welds on the remaining flange.
| Installation | -
Floor panel - Continuous MIG seam weld
- Puddle weld.
- Weld on the spare wheel bracket.
| | -
General Instructions. - For the most part, the damping matting can be adhesively bonded over the weld seam.
| | |